JBL 2022H PDF

JBL H (8Ohm). Unavailable. Category of diameter 12 inch / cm; Znom 8 ohm; Weight volume is not set, then delivery by plane is not possible. Brand New JBL H 12″ Aftermarket Recone Kit, 8 ohm. Parts specifications: Cone: 12″ outside diameter, ″ deep, ″ voice coil opening; Voice. Subwoofer JBL H. General specifications: diameter 12 inches, maximum power W. Thiele-Small parameters: frequency of self resonance Fs=75 Hz, .

Author: Votilar Migrel
Country: Republic of Macedonia
Language: English (Spanish)
Genre: Environment
Published (Last): 24 September 2006
Pages: 464
PDF File Size: 15.77 Mb
ePub File Size: 16.82 Mb
ISBN: 599-8-92434-246-7
Downloads: 68508
Price: Free* [*Free Regsitration Required]
Uploader: Nikogul

Please update your browser to use Reverb

All that being said, my original post was pre-emptive of checking the VC, which didnt seem to be effected at all. I do have a set of ‘s sitting around but they are the midrange version.

Thanks to everyone, good info all around. Is it worth while to recone?

February 21, Like every job, it had it’s ups and downs. But it has been a few years. That is a factor determined by the enclosure and crossover. Read times Brian Elstro Jr.

It has been quite a few years since I was doing reconing-but I remember that the magnet thickness was different between them. The x came in 3 versions listed below. It sounds to me that you would prefer the ‘s over ‘s for mid use. Suprisingly enough it didnt sound too bad last night, but a real re-cone kit is in order. However the magnet structures and magnetic energy focusing are different-so you will end jnl some sort of “half breed”.

  ASME B18.22.1 PDF

JBL 2022H 12″ Aftermarket Recone Kit

February 24, The letter following the is used to designate the impedence. February 19, Write a poem to a friend, even a lousy poem. Logged Brian Elstro Jr. I’ll leave the flame suit on for this Do it as well as you possible can. There was a ridge left behind from the old dustcap jbp so I had to score the new cone near the former to get it to lay down flat, but once 0222h the pre-fit was done, glue-ing it in wasnt too big of an issue rubber cement You will have created something. Differences were achieved in cone composition, coil windings, and VC former material.

Results 1 to 5 of 5. Ditto E, E, and I think they both fall inbetween the “producer” and “reproducer” sound Dance to the radio.

Subwoofer JBL H specifications.

Last edited by maxwedge; at I don’t know anything about the With proper processing do you think that it would be a good idea to just stick the in and work it out, while re-coning the I have compared these side by side jbk could not find any difference in the basket. I thought the magnet slab was thicker.

  AMBYSTOMA VELASCI PDF

February 18, For a temporary fix I removed an older cone from another torched woofer, removed its suspension and dustcap, carefully removed the dustcap from the jbl and trimmed the glue from the cone as well as I could.

Please login or register. In most cases-similar older JBLS can jvl reconed “kinda” as different model. By that I mean the kits will interchange physically.

I’ve been thinking of replacing my ‘s with ‘s down the road a bit and if ‘s can be reconed as ‘s then that could be an option I used them as both side fill monitor and jb range interchangeably and the has better low end while the is better for vocals.